Dell N1100-ON, Reference Manual

Page: 1561 / 2332

Layer 3 Routing Commands
1561
Gi1/0/2 431 6599
show ipv6 traffic
Use the show ipv6 traffic command in User Exec mode to show traffic and
statistics for IPv6 and ICMPv6.
Syntax
show ipv6 traffic [ vlan vlan-id | tunnel tunnel-id | loopback loopback-id]
• vlan-id — Valid VLAN ID, shows information about traffic on a specific
interface or, without the optional parameter, shows information about
traffic on all interfaces.
• tunnel-id — Tunnel identifier. (Range: 0-7)
• loopback-id — Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
User Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Examples
The following examples show traffic and statistics for IPv6 and ICMPv6, first
for all interfaces and an individual VLAN.
console> show ipv6 traffic
IPv6 STATISTICS
Total Datagrams Received........................................... 0
Received Datagrams Locally
Delivered.......................................... 0
Received Datagrams Discarded Due To Header Errors.. 0
Received Datagrams Discarded Due To MTU............ 0
Received Datagrams Discarded Due To No Route....... 0
Received Datagrams With Unknown Protocol........... 0
Received Datagrams Discarded Due To Invalid Address.0