Dell N1100-ON, Reference Manual

Page: 1262 / 2332

Layer 3 Routing Commands
1262
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router-af)#maximum-paths ibgp 5
neighbor activate
Use this command to enable the exchange of IPv6 routes with a neighbor. To
disable the exchange of IPv6 addresses, use the no form of this command.
Syntax
neighbor { ip-address | ipv6-address [ interface interface-id ]| autodetect
interface interface-id }} activate
no neighbor { ip-address | ipv6-address [ interface interface-id ]| autodetect
interface interface-id }} activate
• ip-address—The IP address of a peer.
• ipv6-address—The IPv6 address of a peer.
• interface-id — If the neighbor’s IPv6 address is a link local address, the
local interface must also be specified. This must be a VLAN routing
interface and is specified using the VLAN keyword.
• autodetect interface interface-id—(Optional) The routing interface on
which the neighbor’s link local IPv6 address is auto detected. The
interface-id must be a VLAN routing interface. Range is 1–4093.
Default Configuration
The exchange of IPv6 routes is disabled by default.
Command Mode
IPv4 Address Family Configuration mode, IPv6 Address Family
Configuration mode
User Guidelines
The neighbor address must be the same IP address used in the neighbor
remote-as command to create the peer.