Dell N1100-ON, Reference Manual

Page: 1786 / 2332

Layer 3 Routing Commands
1786
• bgp — Redistributes BGP originated routes.
• connected — Redistributes directly-connected routes.
Default Configuration
metric integer — not configured
match — internal
Command Mode
Router RIP Configuration mode.
User Guidelines
When redistributing a route metric, the receiving protocol must understand
the metric. The OSPF metric is a cost value equal to 10
8
/ link bandwidth in
bits/sec. For example, the OSPF cost of GigabitEthernet is 1 = 10
8
/10
8
= 1.
The RIP metric is a hop count with a maximum value of 15.
Dell EMC Networking RIP does not support sending a tag value.
Redistribution of BGP-originated routes is only available on BGP-enabled
routers. Redistribution of BGP-originated routes into RIP is not
recommended.
Example
console(config-router)#redistribute ospf metric 10 match nssa-external 1
console(config-router)#redistribute connected metric 1
router rip
Use the router rip command in Global Configuration mode to enter Router
RIP mode.
Syntax
router rip
Default Configuration
RIP is globally enabled by default. RIP is not enabled on any interfaces by
default.