Dell N1100-ON, Reference Manual

Page: 2183 / 2332

Switch Management Commands
2183
where weight = 2 / ((TotalTimePeriod/samplePeriod) + 1). The sample
period is 5 seconds. The utilization monitoring time period can be configured
from 5 secs to 86400 seconds in multiples of 5 seconds.
Setting a threshold or interval to 0 disables that individual function.
The falling-threshold percentage should be configured to be less than or
equal to the rising-threshold percentage. The switch reports the task level
CPU utilization for the last 5 second, 1 minute and 5 minute periods. To aid
the operator in troubleshooting when the CPU utilization has crossed the
rising threshold, the show proc cpu command has been extended to show the
task/total CPU utilization for the rising threshold period also. If the
utilization thresholds are not configured, then the utilization for last 5 secs, 1
minute and 5 minutes is displayed as before. The CPU utilization for any
given period is displayed in only after the first average has been calculated
over the time period.
For instance, the 5 minute average is shown only after the switch has been up
for more than 5 minutes. Additionally, whenever a time-period is configured
for CPU utilization monitoring, the existing utilization data for the time-
period is cleared and average is built again over the time period. This is done
to prevent generation of notifications based on the old utilization data.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config)#process cpu threshold type total rising 90 interval 100
quit
Use this command to disconnect the serial connection to the remote unit on
the stack member.
Syntax
quit
Default Configuration
There is no default configuration for this command.