Dell N1100-ON, Reference Manual

Page: 1268 / 2332

Layer 3 Routing Commands
1268
subsequent retry doubles the previous retry interval. So by default, the TCP
connection is retried after 2, 4, and 8 seconds. If none of the retries is
successful, the adjacency is reset to the IDLE state and the IDLE hold timer
is started. BGP skips the retries and transitions to IDLE state if TCP returns
an error, such as destination unreachable, on a connection attempt. The
VLAN interface must also be specified if a link-local address is specified.
Command History
Introduced in version 6.2.0.1 firmware.
Updated in version 6.3.0.1 firmware.
Example
console(config-router)#neighbor FE80::0202:B3FF:FE1E:8329 interface vlan 10
connect-retry-interval 10
neighbor default-originate (BGP Router
Configuration)
To configure BGP to originate a default route to a specific neighbor, use the
neighbor default-originate command in BGP Router Configuration mode.
Syntax
neighbor { ip-address | ipv6-address [ interface interface-id]} default-
originate [ route-map map-name]
• interface-id—A routing interface identifier (VLAN interface).
• ip-address—The neighbor’s IPv4 address.
• ipv6-address —The neighbor’s IPv6 address. If the neighbor’s IPv6 address
is a link local address, the local interface must also be specified.
• map-name—(Optional) A route map may be configured to set attributes
on the default route advertised to the neighbor.
Default Configuration
No default is originated by default.