Dell N1100-ON, Reference Manual

Page: 1296 / 2332

Layer 3 Routing Commands
1296
• ip-address — The neighbor’s IPv4 address.
Default Configuration
Peers are not route reflector clients by default.
Command Mode
BGP Router Configuration
User Guidelines
Normally, a router does not re-advertise BGP routes received from an internal
peer to other internal peers. If you configure a peer as a route reflector client,
this router will re-advertise such routes. A router is a route reflector if it has
one or more route reflector clients. Configuring the first route reflector client
automatically makes the router a route reflector.
If you configure multiple route reflectors within a cluster, you must configure
each route reflector in the cluster with the same cluster ID. Use the bgp
cluster-id command to configure a cluster ID.
An external peer may not be configured as a route reflector client.
When reflecting a route, BGP ignores the set statements in an outbound
route map to avoid causing the receiver to compute routes that are
inconsistent with other routers in the AS.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router)#neighbor 10.130.14.55 route-reflector-client
neighbor route-reflector-client (IPv6 Address
Family Configuration)
To configure an internal peer as an IPv4 route reflector client, use the
neighbor route-reflector-client command.