Dell N1100-ON, Reference Manual

Page: 383 / 2332

Layer 2 Switching Commands
383
On a storm control enabled interface, if the ingress rate of that type of packet
(L2 broadcast, multicast, or unicast) is greater than the configured threshold
level (as a percentage of port speed or as an absolute packets-per-second rate),
the switch forwarding-plane discards the excess traffic.
The
speed command controls interface link speeds and auto-negotiation. If
speed is set to something other than auto, auto-negotiation is disabled on the
interface. Auto-negotiation will link at the highest possible speed supported
on the interface at full duplex.
Commands in this Section
This section explains the following commands:
clear counters
Use the clear counters command to clear statistics on an interface.
Syntax
clear counters [ vrf vrf-name | stack-ports | switchport | interface-id]
• vrf-name—The name of the VRF instance on which the command
operates.
• stack-ports —Clears stack-port statistics.
• switchport —Clear all the interface counters
clear counters show interfaces
configuration
show storm-control
description show interfaces counters show storm-control action
flowcontrol show interfaces debounce shutdown
interface show interfaces description speed
interface range show interfaces detail switchport protected
link debounce time show interfaces status switchport protected name
rate-limit cpu show interfaces transceiver show switchport protected
show interfaces show statistics show system mtu
show interfaces advertise show statistics switchport system jumbo mtu