Dell N1100-ON, Reference Manual

Page: 1722 / 2332

Layer 3 Routing Commands
1722
Example
The following example creates an area range for the area 1 NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 range 2020:1::1/64 summarylink
area stub
Use the area stub command in Router OSPFv3 Configuration mode to create
a stub area for the specified area ID. If the area has not been previously
created, this command creates the area and then applies the stub distinction.
A stub area is characterized by the fact that AS External LSAs are not
propagated into the area. Removing AS External LSAs and Summary LSAs
can significantly reduce the size of the link state database of routers within
the stub area.
Syntax
area area-id stub [no summary]
no area area-id stub [no summary]
• area-id — Valid OSPFv3 area identifier.
•
no-summary —Disable the import of Summary LSAs for the stub area
identified by area-id.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example creates a stub area for area 1.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 stub