Dell N1100-ON, Reference Manual

Page: 1962 / 2332

Switch Management Commands
1962
console(config)#ip routing
console(config)#interface vlan 10
console(config-if-vlan10)#ipv6 enable
console(config-if-vlan10)#ipv6 address dhcp
Configure a default gateway on vlan 10
console(config)#no ipv6 address autoconfig
console(config)#no ipv6 address 2003::6/64
console(config)#no ipv6 address 2001::/64 eui64
console(config)#no ipv6 address
ipv6 address (OOB Port)
Use the ipv6 address command in Interface (out-of-band) Configuration
mode to set the IPv6 prefix on the out-of-band port. If a prefix is specified,
the address will be configured using the prefix and length A link local address
in EUI-64 format may also be assigned.
The autoconfig parameter specifies that a link local address in the EUI-64
format is assigned to the interface.
The DHCP parameter indicates that the port should obtain its address via
DHCP.
Use the
no form of the command to remove a specific address or to return the
address assignment to its default value. Using the no form of the command
with no parameters removes all IPv6 prefixes from the interface.
Syntax
ipv6 address {prefix/prefix-length [ eui64 ] | autoconfig | dhcp }
no ipv6 address {prefix/prefix-length [ eui64 ] | autoconfig | dhcp }
• prefix/prefix-length—An IPv6 prefix in global format address format.
•
eui64 —Formulate the prefix in EUI-64 format.
• autoconfig —Perform IPv6 auto-configuration.
• dhcp —Obtain the prefix via DHCP.
Default Configuration
No address is assigned to the out-of-band interface by default.