Dell N1100-ON, Reference Manual

Page: 1950 / 2332

Switch Management Commands
1950
User Guidelines
This command is not available on the N1100-ON/N1500/N2000 Series
switches, nor on the N2128PX-ON switch.
Example
console(config)#interface out-of-band
console(config-if)#
ip address
Use the ip address command in Interface Configuration mode to configure
an IP address on an in-band interface. Also use this command to configure
one or more secondary IP addresses on the interface. The ip address none
command clears the currently assigned IPv4 address and sets the IP address
configuration method to none . The no ip address command clears the
currently assigned IPv4 address sets the IP address configuration method to
the default (whatever the default is). Use the show ip interface command to
display the configured IP addresses.
Syntax
ip address ip-address {subnet-mask | prefix-length} [ secondary ]
no ip address ip-address {subnet-mask | prefix-length} [ secondary ]
• ip-address — IP address of the interface.
• subnet-mask — Subnet mask of the interface
• prefix-length — Length of the prefix. Must be preceded by a forward slash
(/). (Range: 1-30 bits)
• secondary — Indicates the IP address is a secondary address.
Default Configuration
The N1500/N2000/N2100-ON default IPv4 address assignment method is
DHCP on VLAN 1.
The N3000/N3100/N4000 default IPv4 address assignment method on VLAN
1 is none.