Dell N1100-ON, Reference Manual

Page: 1811 / 2332

Layer 3 Routing Commands
1811
vrrp ip
Use the vrrp ip command in Interface Configuration mode to enable VRRP
and set the virtual router IP address value for an interface. Use the no form of
the command remove the secondary IP address. It is not possible to remove
the primary IP address once assigned. Remove the VRRP group instead.
Syntax
vrrp group ip ip-address [ secondary ]
no vrrp group ip ip-address vlan secondary
• group—The virtual router identifier. (Range: 1-255)
• ip-address—The IP address of the virtual router.
•
secondary —Designates the virtual router IP address as a secondary IP
address on an interface.
Default Configuration
VRRP is not configured on the interface.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
The virtual router IP addresses must be a valid host address on the local
subnet based on the IP address and subnet mask configured on the VLAN
interface. The VRRP IP address cannot be either the broadcast address or a
network address. To configure vrrp, perform the following steps:
1 Enable ip routing in global configuration mode.
2 Enable ip vrrp globally.
3 Set an IP address on the desired interface where VRRP is to be configured.
4 Configure the VRRP group ID on the selected interface.
5 Set the virtual router ID and address on the selected interface.
6 Enable VRRP on the interface using the vrrp mode command.