Dell N1100-ON, Reference Manual

Page: 821 / 2332

Layer 2 Switching Commands
821
• add —Associates the secondary VLAN with the primary one.
• remove —Deletes the secondary VLANs from the primary VLAN
association.
• secondary-vlan-list —A list of secondary VLANs to be mapped to a primary
VLAN.
Default Configuration
This command has no default association or mapping configuration.
Command Mode
Interface Configuration (physical or port-channel)
User Guidelines
This command has no user guidelines.
Example
console(config)#vlan 10,20
console(config-vlan10,20)#exit
console(config)#interface gigabitethernet 1/0/8
console(config-if-Gi1/0/8)#switchport private-vlan host-association 10 20
switchport trunk
Use the switchport trunk command in Interface Configuration mode to
configure VLAN membership for a trunk port or to set the native VLAN for
an interface in Trunk Mode.
Syntax
switchport trunk { allowed vlan vlan–list | native vlan vlan–id}
no switchport trunk { allowed | native } vlan
•
vlan–list
—Set the list of allowed VLANs that can receive and send traffic
on this interface in tagged format when in trunking mode. The default is
all . The vlan–list format is as follows:
The vlan-list format is all | [add | remove | except] vlan–atom [, vlan–
atom...] where: