Dell N1100-ON, Reference Manual

Page: 1680 / 2332

Layer 3 Routing Commands
1680
AutoCost Ref BW The configured autocost reference bandwidth. This value is used
to determine the OSPF metric on its interfaces. The reference
bandwidth is divided by the interface speed to compute the
metric.
Default Passive
Setting
When enabled, OSPF interfaces are passive by default.
Maximum Paths Shows the maximum number of paths that OSPF can report for
a given destination.
Default Metric Default metric for redistributed routes.
Stub Router
Configuration
One of Always , Startup , or None .
Stub Router
Startup Time
Configured value in seconds. This row is only listed if OSPF is
configured to be a stub router at startup.
Summary LSA
Metric Override
One of Enabled (met), Disabled , where met is the metric to be
sent in summary LSAs when in stub router mode.
BFD Enabled The BFD status.
Default Route
Advertise
When enabled, OSPF originates a type 5 LSA advertising a
default route.
Always When this option is configured, OSPF only originates a default
route when the router has learned a default route from another
source.
Metric Shows the metric for the advertised default routes. If the metric
is not configured, this field is not configured.
Metric Type Shows whether the metric for the default route is advertised as
External Type 1 or External Type 2.
Number of Active
Areas
The number of OSPF areas to which the router is attached on
interfaces that are up.
ABR Status Shows whether the router is an OSPF Area Border Router.
ASBR Status Indicates whether the router is an autonomous system border
router. Router automatically becomes an ASBR when it is
configured to redistribute routes learned from another protocol.
The possible values for the ASBR status is enabled (if the router
is configured to redistribute routes learned by other protocols) or
disabled (if the router is not configured for the same).
Stub Router Status One of Active or Active .