Dell N1100-ON, Reference Manual

Page: 449 / 2332

Layer 2 Switching Commands
449
Example
console#show green-mode gi1/0/1
Energy Detect Admin Mode............ Enabled
Operational Status.................. Active
Reason.............................. No Energy Detected
Short Reach Feature................. Not Available
EEE Admin Mode...................... Enabled
Rx Low Power Idle Event Count....... 0
Rx Low Power Idle Duration (uSec)... 0
Tx Low Power Idle Event Count.... 0
Tx Low Power Idle Duration (uSec) 0
Tw_sys_tx (usec)..................17
Tw_sys_tx Echo(usec)..............17
Tw_sys_rx (usec)..................17
Tw_sys_tx Echo(usec)..............17
Fallback Tw_sys (usec)............17
Remote Tw_sys_tx (usec)...........21
Remote Tw_sys_tx Echo(usec).......21
Remote Tw_sys_rx (usec)...........21
Remote Tw_sys_tx Echo(usec).......21
Remote fallback Tw_sys (usec).....21
Tx DLL enabled....................Yes
Tx DLL ready......................Yes
Rx DLL enabled....................Yes
Rx DLL ready......................Yes
Cumulative Energy Saving (W * H)..2.37
Time Since Counters Last Cleared..1 day 20 hr 47 min 34 sec
show green-mode
Use the show green-mode command to display the green-mode configuration
for the whole system. The status is shown only for the modes supported on
the corresponding hardware platform whether enabled or disabled.
Time Since
Counters Last
Cleared
Time Since Counters Last Cleared (since the time of power up,
or after clear eee counters is executed)
Term Description