Dell N1100-ON, Reference Manual

Page: 386 / 2332

Layer 2 Switching Commands
386
parameter. 10G/40G fiber ports do not support auto-negotiation and
therefore require the operator to enter the duplex full command and the
speed command with the desired operating bandwidth. Auto-negotiation is
required on 1G/10G/40G copper ports and 1G fiber ports.
The duplex command is only available on the Dell EMC Networking N1500
Series switches. Other switch models support full duplex operation only.
Example
The following example configures the duplex operation of TenGigabit
Ethernet port Te 1/0/5 to force full duplex operation, disable auto-
negotiation, and set the speed to 1000M.
console(config)# interface te1/0/5
console(config-if-Te1/0/5)# duplex full
console(config-if-Te1/0/5)# speed 1000
flowcontrol
Use the flowcontrol command in Global Configuration mode to configure
the flow control. To disable flow control, use the no form of this command.
Syntax
flowcontrol receive {on | off}
no flowcontrol receive
Default Configuration
Flow Control is enabled by default.
Command Mode
Global Configuration and Interface Configuration modes
User Guidelines
Dell EMC Networking switches implement receive flow control only. They
never issue a flow control PAUSE frame when congested, but do respect
received flow control PAUSE frames received from other switches. Disabling
flow control causes the switch to ignore received PAUSE frames.
Interface specific configuration overrides any global configuration.