Dell N1100-ON, Reference Manual

Page: 2124 / 2332

Switch Management Commands
2124
Syntax
enable
no enable
Default Configuration
By default, the default server is enabled. It may be disabled using the no
enable form of the command.
Command Mode
Support Assist Configuration
User Guidelines
Only one SupportAssist server may be enabled. If contact with the server fails,
the switch sleeps for the quiet period (default 1 hour) before attempting
contact again.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console(config)# support-assist
console(conf-support-assist)#server New-Server
console(conf-support-assist-NewServer)#enable
proxy-ip-address
Use the proxy-ip-address command to configure a proxy server to be used to
contact the SupportAssist servers. Use the no form of the command to
remove the proxy server information.
Syntax
proxy-ip-address {ipv4-address | ipv6-address} port port-number username
userid password [encryption-type] password
no proxy-ip-address
• ipv4-address — The IPv4 address of the proxy server in dotted decimal
notation.