Dell N1100-ON, Reference Manual

Page: 2122 / 2332

Switch Management Commands
2122
Command Mode
Support Assist Configuration
User Guidelines
This information is transmitted to Dell if the SupportAssist service is
enabled.
This command can be executed multiple times. It overwrites the previous
information each time. The collected information is stored in the running-
config. The administrator must write the configuration in order to persist it
across reboots.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console(config)# support-assist
console(conf-support-assist)#contact-company name “Dell Inc.“ street-address
“5 Round Rock Way“ city “Round Rock, TX“ country USA postcode 78665
contact-person
Use the contact-person command to configure the contact information to be
sent to the SupportAssist server. Use the no form of the command to remove
the contact information.
Syntax
contact-person first firstname last lastname email-address primary
emailaddress phone phone-number p referred-method { email | phone }
no contact-person
• firstname — The first name of the technical contact person. Maximum
of 50 printable characters.
• lastname — The last name of the technical contact person. Maximum
of 50 printable characters.
• email-address primary —The primary email address of the technical
contact. Maximum of 50 printable characters.