Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
management route
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {{
ipv4-address]/mask
| {
forwarding-router-
address
| managementethernet}
To remove a static route, use the
no management route{{
ip-address mask
| {
ipv6-address prefix-length
}}{
forwarding-router-address
|
managementethernet}
command.
Parameters
ipv4-address]/
mask
Enter an IPv4 Address (A.B.C.D) then the prefix-length for the
IP address of the management interface.
forwarding-
router-address
Enter an IPv4 address of a forwarding router.
managementet
hernet
Enter the keyword
managementethernet
for the
Management interface.
Defaults
Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When a static route (or a protocol route) overlaps with Management static route,
the static route (or a protocol route) is preferred over the Management Static route.
Also, Management static routes and the Management Connected prefix are not
reflected in the hardware routing tables. Separate routing tables are maintained for
IPv4 and IPv6 management routes. This command manages both tables.
Related
Commands
interface ManagementEthernet
— configures the Management port on the system.
show arp
Display the ARP table.
Syntax
show arp [interface
interface
| ip
ip-address
[
mask
] |
macaddress
mac-address
[
mac-address mask
]] [static | dynamic]
[summary]
IPv4 Routing
635
