ip-any
Enter the keyword
ip-any
to support IPv4 and IPv6 traffic.
ip-
precedence-list
Enter the IP precedence value(s) as the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is from
0 to 7.
set-ip-dscp
value
(OPTIONAL) Enter the keywords
set-ip-dscp
then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults
none
Command
Modes
CLASS-MAP CONFIGURATION (config-class-map)
Command
History
Version 9.5(0.0)
Introduced the support for ipv6 and ip-any options on the
MXL 10/40GbE Switch.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To access this command, enter the
class-map
command. After the class map is
identified, you can configure the match criteria.
The
match ip precedence
command and the
match ip dscp
command are
mutually exclusive.
Up to eight precedence values can be matched in one match statement. For
example, to indicate the IP precedence values 0 1 2 3, enter either the
match ip
precedence 0-3
or
match ip precedence 0,1,2,3
command.
NOTE: Only one of the IP precedence values must be a successful match
criterion, not all of the specified IP precedence values must match.
Related
Commands
class-map
— identifies the class map.
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
Syntax
match mac access-group {
mac-acl-name
}
Parameters
mac-acl-name
Enter a MAC ACL name. Its contents is used as the match
criteria in the class map.
Defaults
none
1086
Quality of Service (QoS)
