Command
History
Version 9.3(0.0)
Introduced on the MXL 10/40GbE Switch with the FC Flex IO
module.
Usage
Information
Use the
dcb-map
command to configure priority groups with PFC and/or ETS
settings and apply them to Ethernet interfaces.
Use the
priority-pgid
command to map 802.1p priorities to a priority group.
You can assign each 802.1p priority to only one priority group. A priority group
consists of 802.1p priority values that are grouped together for similar bandwidth
allocation and scheduling, and that share latency and loss requirements. All 802.1p
priorities mapped to the same queue must be in the same priority group.
Repeat the
priority-group bandwidth pfc
command to configure PFC and
ETS traffic handling for each priority group in a DCB map.
You can enable PFC on a maximum of two priority queues.
If you configure more than one priority group as strict priority, the higher
numbered priority queue is given preference when scheduling data traffic.
If a priority group does not use its allocated bandwidth, the unused bandwidth is
made available to other priority groups.
To remove a priority-group configuration in a DCB map, enter the
no priority-
group bandwidth pfc
command.
By default, equal bandwidth is assigned to each dot1p priority in a priority group.
Use the
bandwidth
parameter to configure the bandwidth percentage assigned to
a priority group. The sum of the bandwidth allocated to all priority groups in a DCB
map must be 100% of the bandwidth on the link. You must allocate at least 1% of
the total port bandwidth to each priority group.
Related
Commands
dcb-map
– creates a DCB map to configure PFC and ETS parameters and applies
the PFC and ETS settings on Ethernet ports.
priority-pgid
– configures the 802.1p priority traffic in a priority group for a DCB
map.
scheduler
Configure the method used to schedule priority traffic in port queues.
Syntax
scheduler
value
To remove the configured priority schedule, use the
no scheduler
command.
Parameters
value
Enter schedule priority value. The valid values are:
•
strict
: strict-priority traffic is serviced before any other
queued traffic.
1388
FC Flex IO Modules
