Command
History
Version 9.3.0.0
Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the
show interface
dcbx detail
command.
dcbx version
Configure the DCBX version used on the interface.
Syntax
dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBX version, use the
dcbx version {auto | cee | cin |
ieee-v2.5}
command.
Parameters
auto | cee | cin
| ieee-v2.5
Enter the DCBX version type used on the interface, where:
•
auto
: configures the port to operate using the DCBX
version received from a peer.
•
cee
: configures the port to use CDD (Intel 1.01).
•
cin
: configures the port to use Cisco-Intel-Nuova (DCBX
1.0).
•
ieee-v2
: configures the port to use IEEE 802.1az (Draft
2.5).
Defaults
Auto
Command
Modes
INTERFACE PROTOCOL LLDP
Command
History
Version 9.3.0.0
Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the
show interface
dcbx detail
command.
debug dcbx
Enable DCBX debugging.
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail |
mgmt | resource | sem | tlv}
1380
FC Flex IO Modules
