show ip cam stack-unit
Display CAM entries.
Syntax
show ip cam stack-unit {
0–5
} [port-set {
pipe-number
} | {
ip-
address mask
[longer-prefixes]| detail | member-info | summary]
Parameters
0–5
Enter the stack-unit ID from 0 to 5
pipe-number
Enter the number of the Port-Pipe number. The range is
from 0 to 0
ip-address
mask
[longer-
prefixes]
(OPTIONAL) Enter the IP address and mask of a route to
CAM entries for that route only. Enter the keywords
longer-
prefixes
to view routes with a common prefix.
detail
Enter the keyword
detail
to display the group index ID
used by the ecmp routes in the CAM.
member-info
Enter the keywords
member-info
to display the group index
used by the ecmp, the number of egress ports (members) for
the ecmp, and the port details of each member.
The detail information under
member-info
gives the MAC
address, VLAN ID, and gateway of every member port of the
ecmp.
summary
(OPTIONAL) Enter the keyword
summary
to view a table
listing route prefixes and the total number routes which can
be entered in to CAM.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the
show ip cam
command shown in the following
example.
Field
Description
Destination
Displays the destination route of the index.
EC
Displays the number of equal cost multipaths (ECMP)
available for the default route for non-Jumbo line cards. For
Jumbo line cards, displays 0,1 when ECMP is more than
eight.
CG
Displays 0.
V
Displays a 1 if the entry is valid and a 0 otherwise.
640
IPv4 Routing
