Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0)
Introduced on the Z9000, S6000, S4820T, S4810, MXL
match ip access-group
Configure match criteria for a class map, based on the access control list (ACL).
Syntax
match ip access-group
access-group-name
[set-ip-dscp
value
]
To remove ACL match criteria from a class map, use the
no match ip access-
group access-group-name [set-ip-dscp
value
]
command.
Parameters
access-group-
name
Enter the ACL name whose contents are used as the match
criteria in determining if packets belong to the class the
class-map
specifies.
set-ip-dscp
value
(OPTIONAL) Enter the keywords
set-ip-dscp
then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults
none
Command
Modes
CLASS-MAP CONFIGURATION (config-class-map)
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To access this command, enter the
class-map
command. After the class map is
identified, you can configure the match criteria. For class-map match-any, a
maximum of five ACL match criteria are allowed. For
class-map match-all
,
only one ACL match criteria is allowed.
Related
Commands
class-map
— identifies the class map.
match ip vlan
Uses a VLAN as the match criterion for an L3 class map.
Syntax
match ip vlan
vlan-id
To remove VLAN as the match criterion, use the
no match ip vlan
vlan-id
command.
1082
Quality of Service (QoS)
