Dell(conf-if-te-0/20)#no portmode hybrid
Dell(conf-if-vl-20)#
Related
Commands
show interfaces switchport
— displays the configuration of switchport (Layer 2)
interfaces on the switch.
vlan-stack trunk — specifies an interface as a trunk port to the Stackable VLAN
network.
stack-unit portmode
Split a single 40G port into 4-10G ports on the MXL switch.
Syntax
stack-unit
stack-unit
port
number
portmode quad
Parameters
stack-unit
Enter the stack member unit identifier of the stack member
to reset. The range is 0 to 5.
NOTE: The MXL switch commands accept Unit ID
numbers from 0 to 5, though the MXL switch supports
stacking up to three units only with the Dell Networking
OS version 8.3.7.1.
number
Enter the port number of the 40G port to be split. Enter one
of the following port numbers for the MXL switch: 48, 52, 56,
or 60.
Defaults
Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Splitting a 40G port into 4x10G port is supported on standalone and stacked units.
• You cannot use split ports as stack-link to stack an MXL Switch.
• The split ports MXL switch unit cannot be a part of any stacked system.
• The unit number with the split ports must be the default (stack-unit 0).
• This set up can be verified using
show system brief
command. If the unit ID
is different than 0, it must be renumbered to 0 before ports are split by using
the
stackunit id renumber 0
command in EXEC mode.
The quad port must be in a default configuration before it can be split into 4x10G
ports. The 40G port is lost in the config when the port is split, so be sure that the
port is also removed from other L2/L3 feature configurations.
1478
PMUX Mode of the MXL 10/40GbE Switch I/O Module
