Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
A route reflector reflects routes to the neighbors assigned to the cluster. Neighbors
in the cluster do not need not to be fully meshed. By default, when you use
no
route reflector
, the internal BGP (IBGP) speakers in the network must be fully
meshed.
The first time you enter this command, the router configures as a route reflector
and the specified BGP neighbors configure as clients in the route-reflector cluster.
When you remove all clients of a route reflector using the
no neighbor route-
reflector-client
command, the router no longer functions as a route
reflector.
If the clients of a route reflector are fully meshed, you can configure the route
reflector to not reflect routes to specified clients by using the
no bgp client-
to-client reflection
command.
Related
Commands
bgp client-to-client reflection
— enables route reflection between the route
reflector and the clients.
neighbor shutdown
Disable a BGP neighbor or peer group.
Syntax
neighbor {
ip-address
|
peer-group-name
} shutdown
To enable a disabled neighbor or peer group, use the
neighbor {
ip-address
|
peer-group-name
} no shutdown
command.
Parameters
ip-address
Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to disable or enable all
routers within the peer group.
Defaults
Enabled (that is, BGP neighbors and peer groups are disabled.)
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Border Gateway Protocol IPv4 (BGPv4)
353
