ip msdp peer
Configure an MSDP peer.
Syntax
ip msdp peer
peer address
[connect-source] [description] [sa-
limit
number
]
To remove the MSDP peer, use the
no ip msdp peer
peer address
[connect-source
interface
] [description
name
] [sa-limit
number
]
command.
Parameters
peer address
Enter the peer address in a dotted decimal format (A.B.C.D.).
connect-
source
interface
Enter the keywords
connect-source
then one of the
interfaces and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet
then the slot/ port information.
• For a Loopback interface, enter the keyword
loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a VLAN, enter the keyword
vlan
then a number from
1 to 4094.
description
name
(OPTIONAL) Enter the keyword
description
then a
description name (maximum 80 characters) to designate a
description for the MSDP peer.
sa-limit
number
(OPTIONAL) Enter the maximum number of SA entries in SA-
cache. The range is from 1 to 500000. The default it
500000
.
Defaults
As described in the
Parameters
section.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The
connect-source
option is used to supply a source IP address for the TCP
connection. When an interface is specified using the
connect-source
option, the
primary configured address on the interface is used.
If the total number of SA messages received from the peer is already larger than the
limit when this command is applied, those SA messages continue to be accepted.
To enforce the limit in such situation, use the
clear ip msdp peer
command to
reset the peer.
892
Multicast Source Discovery Protocol (MSDP)