Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Syslog messages contain the IP address of the interface used to egress the router.
By configuring the
logging source-interface
command, the Syslog packets
contain the IP address of the interface configured.
Related
Commands
logging
— enables logging to the Syslog server.
logging synchronous
Synchronize unsolicited messages and output.
Syntax
logging synchronous [level
level
| all] [limit
number-of-
buffers
]
To disable message synchronization, use the
no logging synchronous [level
level
| all] [limit
number-of-buffers
]
command.
Parameters
all
Enter the keyword
all
to ensure that all levels are printed
asynchronously.
level
level
Enter the keyword
level
then a number as the severity
level. A high number indicates a low severity level and vice
versa. The range is from 0 to 7. The default is
2
.
all
Enter the keyword
all
to turn off all.
limit
number-
of-buffers
Enter the keyword
limit
then the number of buffers to be
queued for the terminal after which new messages are
dropped. The range is from 20 to 300. The default is
20
.
Defaults
Disabled. If enabled without the
level
or
number-of-buffers
options specified,
level =
2
and number-of-buffers =
20
are the defaults.
Command
Modes
LINE
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enable
logging synchronous
, unsolicited messages appear between
software prompts and outputs. Only the messages with a severity at or below the
set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are
discarded, a system message appears on that terminal line. Messages may continue
to appear on other terminal lines.
Simple Network Management Protocol (SNMP) and Syslog
1249
