dscp-list
Enter the IP DSCP values that is to be the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is from
0 to 63.
set-ip-dscp
value
(OPTIONAL) Enter the keywords
set-ip-dscp
then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults
none
Command
Modes
CLASS-MAP CONFIGURATION (config-class-map)
Command
History
Version 9.5(0.0)
Introduced the
ipv6
and
ip-any
options on the MXL
10/40GbE Switch.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To access this command, enter the
class-map
command. After the class map is
identified, you can configure the match criteria.
The
match ip dscp
and
match ip precedence
commands are mutually
exclusive.
Up to 64 IP DSCP values can be matched in one match statement. For example, to
indicate IP DCSP values 0 1 2 3 4 5 6 7, enter either the
match ip dscp
0,1,2,3,4,5,6,7
or
match ip dscp 0-7
command.
NOTE: Only one of the IP DSCP values must be a successful match criterion,
not all of the specified IP DSCP values must match.
Related
Commands
class-map — identifies the class map.
match ip precedence
Use IP precedence values as a match criteria.
Syntax
match {ip | ipv6 | ip-any} precedence ip-
precedence-list
[set-
ip-dscp
value
]
To remove IP precedence as a match criteria, use the
no match {ip | ipv6 |
ip-any} precedence ip-
precedence-list
[[multicast] set-ip-dscp
value
]
command.
Parameters
ip
Enter the keyword
ip
to support IPv4 traffic.
ipv6
Enter the keyword
ipv6
to support IPv6 traffic.
Quality of Service (QoS)
1085
