Loopback 0 is up, line protocol is up
Internet Address 192.168.253.2/32, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type
LOOPBACK, Cost: 1
Loopback interface is treated as a stub Host.
Dell>
show ip ospf neighbor
Display the OSPF neighbors connected to the local router.
Syntax
show ip ospf
process-id
neighbor
Parameters
process-id
Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the
show ip ospf
process-id
neighbor
command
shown in the following example.
Item
Description
Neighbor ID
Displays the neighbor router ID.
Pri
Displays the priority assigned neighbor.
State
Displays the OSPF state of the neighbor.
Dead Time
Displays the expected time until the system declares the
neighbor dead.
Address
Displays the IP address of the neighbor.
Interface
Displays the interface type slot/port information.
Area
Displays the neighbor’s area (process ID).
Example
Dell#show ip ospf 34 neighbor
Neighbor ID Pri State Dead Time Address Interface Area
20.20.20.7 1 FULL/DR 00:00:32 182.10.10.3 Gi 0/0 0.0.0.2
192.10.10.2 1 FULL/DR 00:00:37 192.10.10.2 Gi 0/1 0.0.0.1
20.20.20.1 1 FULL/DROTHER00:00:36 192.10.10.4 Gi 0/1 0.0.0.1
Dell#
972
Open Shortest Path First (OSPFv2 and OSPFv3)
