Example
show running-config rip
!
router rip
distribute-list Test1 in
distribute-list Test21 out
network 10.0.0.0
passive-interface GigabitEthernet 2/0
neighbor 20.20.20.20
redistribute ospf 999
version 2
timers basic
Manipulate the RIP timers for routing updates, invalid, holddown times, and flush time.
Syntax
timers basic update
invalid holddown flush
To return to the default settings, use the
no timers basic
command.
Parameters
update
Enter the number of seconds to specify the rate at which RIP
routing updates are sent. The range is from zero (0) to
4294967295. The default is
30 seconds
.
invalid
Enter the number of seconds to specify the time interval
before routing updates are declared invalid or expired. The
invalid value should be at least three times the update timer
value. The range is from zero (0) to 4294967295. The default
is
180 seconds
.
holddown
Enter the number of seconds to specify a time interval during
which the route is marked as unreachable but still sending
RIP packets. The holddown value should be at least three
times the update timer value. The range is from zero (0) to
4294967295. The default is
180 seconds
.
flush
Enter the number of seconds to specify the time interval
during which the route is advertised as unreachable. When
this interval expires, the route is flushed from the routing
table. The flush value should be greater than the update
value. The range is from zero (0) to 4294967295. The default
is
240 seconds
.
Defaults
• update =
30 seconds
• invalid =
180 seconds
• holddown =
180 seconds
• flush =
240 seconds
1128
Routing Information Protocol (RIP)
