764
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
Service and Maintenance
Backing Up and Recovering Configuration Data
Uploading the Configuration Automatically
Requirements:
•
PBX set to factory settings
•
Configuration file named
auconfig.cfg
saved on a USB memory stick
1. Turn the PBX off.
2. Insert the USB memory stick into the USB port (USB host) on the CPU module.
3. Turn the PBX on.
The configuration data saved on the USB memory stick is automatically saved in the
PBX. Finally, the PBX restarts.
If the
Power
LED lights up in green again, the restart is complete and the PBX is
ready for operation.
Note:
If the
Power
LED remains continuously lit in red, an error has occurred.
Please contact your specialised dealer or the manufacturer directly.
Any network settings saved in the configuration file will be taken over during
automatic uploading. If the network settings were not saved in the configu-
ration file, the factory network settings will be retained.
Warning:
Touching voltage-carrying conductors or telephone connections
can cause life-threatening electric shocks.
•
For some installation and maintenance work, it is necessary to open the
PBX while it is in operation (qualified electrician only). Make sure that the
PBX is never left unattended while working with an open casing. Close
the casing after completing this work.
•
Only a qualified electrician may perform installation work within an open
casing or service work using the buttons inside the casing. If necessary,
commission a specialised dealer to perform this work.
Warning:
Power surges, which can occur during electrical storms, can
cause life-threatening electric shocks and damage or destroy the PBX.
•
Do not open the PBX during an electrical storm.