Installation
Standard Hardware Configurations
2-4
Partisol 2000
i
and Partisol 2000
i
-D Instruction Manual
Thermo Fisher Scientific
Figure 2–2.
Sampler with a Large Rainhood Installed on the Right Side Panel of
the Unit and a Small Rainhood on Left
4.
Install the two small rain hoods. One rain hood is installed on the left
side of the enclosure and the other on the back. Each rain hood covers
one fan opening.
a.
Peel back the paper facing of one of the smaller gaskets and apply it
to one of the smaller rainhoods.
b.
Place the small rainhood, with its gasket attached, on the enclosure.
c.
Secure the rainhood to the unit using four #10-32 x 1/2" slot bind
head screws.
d.
Repeat this procedure for the other small rainhood.
5.
Install the sample tube and PM
10
inlet (
Figure 2–3
).
Note
If using an inlet other than a PM
10
inlet as described in this section,
follow the instructions that were provided with that inlet.
▲
Note
Examine the sample tube. Some sample tubes are machined down to
a smaller diameter on both ends. The machining on one end extends for 5
cm (2 inches), while the machining on the opposite end extends only 3 cm
(1.25 inches).
▲
a.
Insert the end of the sample tube, with the 5 cm (2 inches)
machined section, into the bulkhead of the Sampler. Ensure that
the tube is pushed into the enclosure through the final O-ring until
it stops.
