Installation
Standard Hardware Configurations
Thermo Fisher Scientific
Partisol 2000
i
and Partisol 2000
i
-D Instruction Manual
2-3
Use the following procedure to set up the Sampler. The following
instructions apply to both the Partisol 2000
i
and Partisol 2000
i
-D
Ambient Samplers.
1.
When moving the instrument, be sure to lift the unit by using the two
handles.
2.
Cut any tie wraps and remove any transport restraints from inside the
Sampler enclosure.
3.
Install the large rainhood on the right side of the enclosure (
Figure 2–
1
). The rainhood should cover both air filters.
Figure 2–1.
Rainhood and Self Stick Gasket
a.
Peel back the paper facing of the larger gasket and apply it to the
larger rainhood.
b.
Place the large rainhood, with its gasket attached, on the enclosure
(
Figure 2–2
).
c.
Secure the rainhood to the unit using four #10-32 x 1/2" slot bind
head screws.
Setting up the
Sampler
