Communications Using iPort or RPComm
Using RPComm
D-30
Partisol 2000
i
and Partisol 2000
i
-D Instruction Manual
Thermo Fisher Scientific
Use the following procedure to connect a Series 1400a monitor and a
Partisol 2000
i
-D to a serial switching device.
1.
Set up the 1400a monitor and Sampler for direct communications
(“
Instrument Setup for Direct Communication
” on pge
D-4
).
2.
Create a new connection to each instrument according to “
Creating a
New Connection
” on page
D-7
and verify that the units are
communicating properly.
Note
If the connection is successful, the unit’s serial number will be
displayed at the top of the screen. If the connection is not successful or if
there is no unit attached, then the serial number area will be blank or will
display 99999.
▲
3.
Once the RPComm software and instrument configurations have been
verified, disconnect the direct connection.
4.
Connect your computer directly to the modem that will be connected
to the serial switching device (“RPComm Setup for Use through a
Modem” on page
D-22
).
5.
Begin executing any communication software which will allow direct
communications with the modem. Communication software is usually
included with most standard commercial modems. If no software
program was included with your standard commercial modem, Hyper
Terminal (which is included with the Windows operating system) can
be used.
6.
Set the modem’s communication parameters to work with the Series
1400a monitor. The following
Table D–1
contains the commands that
should be set and their corresponding command codes. Various
commercial (especially older) modems may have different command
codes for the functions listed. Consult your modem’s instruction
manual for the proper commands.
Connecting a Series 1400a
and a Partisol 2000
i
-D
