Electronics and I/O Components
I/O Components
Thermo Fisher Scientific
Partisol 2000
i
and Partisol 2000
i
-D Instruction Manual
13-3
The standard Sampler provides six analog voltage outputs. Each may be
firmware configured for any one of the following ranges, while maintaining
a minimum resolution of 12 bits:
●
0-100mV
●
0-1V
●
0-5V
●
0-10V
The user can calibrate each analog output zero and span point through
firmware. At least 5% of full scale over and under range are also supported,
but may be overridden in firmware if required.
The analog outputs may be assigned to any measurement or diagnostic
channel with a user-defined range in the units of the selected parameter.
The voltage outputs are independent of the current outputs.
The optional I/O expansion board includes six isolated current outputs.
These are firmware configured for any one of the following ranges, while
maintaining a minimum resolution of 11 bits:
●
0-20 mA
●
4-20 mA
The user can calibrate each analog output zero and span point through
firmware. At least 5% of full scale over and under range are also supported,
but may be overridden in firmware if required.
The analog outputs may be assigned to any measurement or diagnostic
channel with a user-defined range in the units of the selected parameter.
The current outputs are independent of the voltage outputs. The current
outputs are isolated from the instrument power and ground, but they share
a common return line (Isolated GND).
Eight analog voltage inputs are used to gather measurement data from
third-party devices. The user may assign a label, unit, and a conversion
table (2 to 10 points). Each point in the conversion table consists of an
analog input voltage value (0-10 V) and a corresponding user-defined
reading value. Only two points are necessary for linear inputs, however a
larger number of points may be used to approximate non-linear inputs. All
voltage inputs have a resolution of 12 bits over the range of 0 to 10 volts.
Analog Voltage
Outputs
Analog Current
Outputs (Optional)
Analog Voltage
Inputs (Optional)
