Installation
Partisol Stand
Thermo Fisher Scientific
Partisol 2000
i
and Partisol 2000
i
-D Instruction Manual
2-9
Sampler Stand Parts List
A (2) Top front and top back (36-005479)
B (4) Top right, top left, bottom right, bottom left (36-005476)
C (4) Legs (36-005478)
D (2) Bottom front and bottom back (36-005477)
E (4) Hex head bolt 1/4-20 x 3/8" (21-001291-0006)
F (20) Hex head bolt 1/4-20 x 3/4" (21-001291-0012)
G (24) Flat washer, 1/4" (21-001275)
H (24) Split ring washer, 1/4" (21-000848)
IMPORTANT
Always remember to place the split ring washer between the
head of the bolt and the washer.
▲
1.
Assemble the bottom of the stand by laying out the front, back and
sides (
Figure 2–8
).
2.
Place one leg on each inside corner and fasten with F, G and H
hardware (
Figure 2–7
).
3.
Attach the top front and back to the outside of the legs with F, G and
H hardware (
Figure 2–7
). Do not tighten.
4.
Fasten the right and left rails to the legs and top front and back rails
with F, G and H hardware (
Figure 2–7
).
5.
Tighten all hardware.
6.
Place the Sampler onto the stand and secure using E, G, and H
hardware (
Figure 2–7
).
