Firmware Screen Descriptions
Service Menu
9-70
Partisol 2000
i
and Partisol 2000
i
-D Instruction Manual
Thermo Fisher Scientific
MANUAL MOTION TESTS:
>PUMP CONTROL 0
VACUUM VENT 0
FLOW LEAK 0
FLOW2 LEAK 0
HEATER CONTROL 0
CTRST SSET INSTS STAT
FC FAN ACT 0
PUMP FAN ACT 0
DISCREET ACTIONS
The Discrete Actions allows the user to choose direct action menu.
●
In the Main Menu, choose Service > Manual Motion >
Discrete
Actions
.
DISCRETE SOLENOID TEST:
>FLOW LEAK 0
FLOW2 LEAK 0
HEATER CONTROL 0
FC FAN ACT 0
PUMP FAN ACT 0
CTRST SSET INSTS STAT
AUX 24 ACT 0
MODEM ACT 0
The Screen Contrast screen is used to change the contrast of the display.
Values between 0 and 100% in increments of 5 are available. Changing the
screen contrast may be necessary if the instrument is operated at extreme
temperatures or lighting conditions.
Notes
The optimal contrast will change with changes in temperature.
▲
The optimal contrast will change from one LCD screen to another. If the
LCD screen is replaced, the contrast may need to be reset.
▲
If the display contrast is not optimal, but the content on the screen is
visible, in the Main Menu, choose Service >
Screen Contrast
, or press the
CTRST soft key on the front panel, and adjust the screen contrast. If the
content on the screen is not visible, use the “set contrast 10” C-Link
command to set the screen contrast to mid range, and then optimize the
contrast. Refer to the “
Hardware Configuration
” section on page
B-20
in
the “
C-Link Protocol Commands
” Appendix for more information on this
command.
Discrete Actions
Screen Contrast
