Remote Control - Commands
R&S NRP
1144.1400.12 6.44
E-3
OUTPut
The OUTPut system serves for generator configuration. The R&S NRP can be equipped with an
optional RF test generator which produces a reference power of 1 mW at 50 MHz. Moreover, the
analog outputs at the rear of the power meter can be configured.
Table 6-8: Commands of the OUTPut system
Command
Parameter
Unit
Remark
OUTPut
:RECorder[1|2]
:FEED[?]
<string>
-
:LIMit
:LOWer[?]
<float_value>
-
The value range of the parameter
depends on the output unit of the
measured value.
:POWer[?]
<float_value>
DBM|
W|DBUV
:RATio[?]
<float_value>
DB|
DPCT|O
:UPPer[?]
<float_value>
-
The value range of the parameter
depends on the output unit of the
measured value.
:POWer[?]
<float_value>
DBM|
W|DBUV
:RATio[?]
<float_value>
DB|
DPCT|O
:STATe[?]
ON|OFF
-
:ROSCillator
[:STATe][?]
ON|OFF
-
Option R&S NRP-B1
:CALibration
:READ?
<NR1>
-
Option R&S NRP-B1
:WRIte
<NR1>,<NR1>
-
Option R&S NRP-B1
:TTL[1]
:ACTive[?]
LOW|HIGH
-
:FAIL[?]
HIGH|LOW
-
:FEED[?]
<string>
-
:HVOLtage
<float_value>
V
:LVOLtage
<float_value>
V
:STATe[?]
ON|OFF
-
OUTPut:RECorder[1..2]:FEED[?] <string>
Assigns a calculate block to one of the two analog outputs. On the basis of the set characteristic, the
measured value is converted to a DC voltage that can be tapped at the appropriate output.
Value range:
"CALC1", "CALC2", "CALC3", "CALC4"
*RST
value:
output 1:
"CALC1"
output 2:
"CALC2"
