R&S NRP
Remote Control - Commands
1144.1400.12 6.1
E-3
6 Remote Control - Commands
Notation
In the following sections, all commands implemented in the device are first listed in a table according to
the command system and then described in detail. For the most part, the notation used complies with
SCPI specifications.
Command tables
For a quick overview of available commands, the commands are listed in a table
before they are described. Except for the high-level measurement commands and
the STATus commands, these tables contain the following four columns.
Command:
The commands and their hierarchical order
(see indentations).
Parameter:
Required parameters.
Unit:
Basic unit of physical parameters.
Remark:
This column indicates which commands
•
do not have a query form
•
are available as a query only
Indentations
The various levels of the SCPI command hierarchy are shown in the table by
indentations to the right. The lower the level, the greater the indentation. It should
be noted that the complete notation of the command always includes the higher
levels.
Example
:
SENSe[1..4]:AVERage:COUNt
is shown in the table as follows:
SENSe[1..4]
first level
:AVERage
second
level
:COUNt
third level
In the individual description, the command is shown in full length. An example of
the command is indicated at the end of the description.
[1 to 4] or [1 to 8]
This notation indicates the numeric suffix of a command. With the SENSe
commands the suffix may assume the values 1 to 4; with the CALCulate and high-
level measurement commands the values 1 to 8. If the suffix is not specified, it is
internally set to 1.
