R&S NRP
Remote Control - Commands
1144.1400.12 6.7
E-3
*PRE 0..255
- Parallel Poll Enable Register Command
Sets the Parallel Poll Enable Register to the defined value.
*PRE?
- Parallel Poll Enable Register Query
Returns the current content of the Parallel Poll Enable Register.
*PSC 0|1
- Power On Status Clear Command
Determines whether the content of the ENABle registers is retained or cleared upon power-up.
*PSC 0
causes the status registers to retain their content. With appropriate configuration of the ESE
and SRE status registers, a service request may be triggered upon power-up.
*PSC 1
clears the registers.
*PSC?
- Power On Status Clear Query
The query *
PSC?
reads out the content of the power-on-status-clear flag. The response can be "0" or
"1" .
*RCL 0..19
- Recall
Calls the device state which has been stored with the
*SAV
command under the indicated number. The
effect of
*RCL 0 to 19
is the same as if one of the setups 0 to 19 had been selected in manual control.
*RCL
0
resets the device to the default state.
*RST
- Reset
Sets the device to the defined default state and has almost the same effect as the SCPI command
SYSTem:PRESet
. (
Table 6-33
). The table also provides default settings. The following table documents
the difference.
SYST:PRES
acts like the frontpanel key
(PRES)
.
INITiate:CONTinuous
SENSe:AVERage:TCONtrol
*RST
OFF REPeat
SYSTem:PRESet
ON MOVing
*SAV 1..19
- Save
Stores the current device state under the indicated number.
