Panasonic AFP7MC16EC, User Manual

Page: 395 / 504

15.4 Warning Code Table
15-31
● :
Recoverable, -: Unrecoverable
Warning
code
Warning
name
Description Object Recovered Countermeasures
0111H
Cam pattern
table over-
writing
warning
The operation for the cam pattern
table rewriting request ended
abnormally as an incorrect value
was set or the execution condition
was not satisfied.
All
axes

- Confirm the setting values of the
parameters required for rewriting
cam patterns.
- Confirm if any axes are in
synchronous operation.
If any, cancel the synchronous
operation and rewrite the cam
pattern tables.
* The details about the cause of
the occurrence of this warning are
stored in the “cam pattern
rewriting result” area of unit
memories.
0120H
Trigger
setting
warning
The trigger condition setting error
occurred. All
axes

Check that the trigger conditions
are set correctly.
0121H
Tool logging
function
enable
warning
When UM02613 is on (logging
enabled), it is detected that YB is
on.
All
axes

After setting UM02613 to off, turn
on the YB (logging enabled).
0300H
Control area
for buffer
control value
warning
The following parameters of the
control area for buffer control is
out of the range.
- Request flag control
- Request code control
- Response code control
- Axis number control
- Starting table number
- Table size
- Extended positioning table
usage setting
- Extended positioning table
usage setting corresponding axis
no.
All
axes
/Each
axis

- Confirm the setting values of the
parameters for control area for
buffer control.
0304H
Recalculation
error warning An error occurred when
recalculation was performed. Each
axis

Even when the error occurred,
recalculation process in which no
error occurs is executed.
Check the settings and execute
the recalculation process again.
(Note): To simplify the displays, only the lower four digits (Hex) of each warning code are displayed in the above table.