Mitsubishi Electric FR-F820-00046, Instruction Manual

Page: 800 / 940

Ethernet communication (FR-F800-E) Parameters
5 - 628
Programming example for setting the operation mode
The following explains a program to write various data to the inverter.
The following program changes the operation mode of the station 1 inverter to network operation.
●
Operation mode write code: HFB (hexadecimal)
●
Network operation set data: H0000 (hexadecimal) (Refer to page 5-622.)
●
The reply code at the time of instruction code execution is set to D2. (Refer to page 5-621.)
I003130E
Fig. 5-291: Programming example 2
(0)
SM1536 SD1536.0 SD1540.0 M0
(4)
M0 X20
PLS M300
(8)
M300
SET M301
10)
M301 X100F
MOV H0FB W102
MOV H0 W103
SET Y100F
RST
M301
SET M302
19)
M302 X100F
MOV W2 D2
RST Y100F
RST M302
25) END
Check the data link status of the station 1.
Write the operation mode write code (HFB)
to RWw2 and the set data (H0000) to RWw3.
Turn ON the instruction code execution request
(RY0F).
Read the reply code (RWr2) to D2 when the
instruction code execution completion (RX0F) turns
ON.
Turn OFF the instruction code execution request
(RY0F).