Mitsubishi Electric FR-F820-00046, Instruction Manual

Page: 685 / 940

Parameters (N) Operation via communication and its settings
FR-F800 5 - 513
R: Read only,
W: Read/Write (Commandable values not supported),
C: Read/Write (Commandable values supported)
Values written to the objects that support the commandable values are stored in the Priority Array,
even when "Write Access Denied" is returned due to inconsistency of the writing requirements
such as the operating mode, on condition that the values are written within the setting range.
If communication speed command source is other than NET, the setting value can be written, but
not to be applied.
When both C42 (Pr. 1136) and C44 (Pr. 1138)
≠
"9999", the setting range is from the smaller
coefficient to the larger coefficient of C42 (Pr. 1136) and C44 (Pr. 1138). Depending on the setting,
the writing value and the reading value may not be the same at the minimum digit.
321
Second PID
measured value
CMD
C
Set the second PID measured value.
This object is the measured value during PID
operation if Pr. 753 = "60 or 61".
(Setting range: 0.00 to 100.00)
no-units (95)
322
Second PID
deviation CMD
C
Set the second PID deviation. (0.01 increment)
This object is the deviation during PID
operation if Pr. 753 = "50 or 51".
(Setting range: -100.00 to 100.00)
percent (98)
398
Mailbox
parameter
W
Access to the properties which are not defined
as objects are available (refer to page 5-516).
no-units (95)
399 Mailbox value W no-units (95)
10007
Acceleration
time
W Sets Pr. 7 "Acceleration time" seconds (73)
10008
Deceleration
time
W Sets Pr. 8 "Deceleration time" seconds (73)
Object
identifier
Object name
Present value
access type
Description Unit
Tab. 5-267: Object assignment for analog values (2)