Mitsubishi Electric FR-F820-00046, Instruction Manual

Page: 705 / 940

Parameters (N) Operation via communication and its settings
FR-F800 5 - 533
GOT2000 series automatic recognition
●
When the GOT2000 series is connected, the parameters required for the GOT connection are
automatically changed by setting the automatic recognition on the GOT2000 series side.
●
Set the station number (Pr. 117 or Pr. 331) of the inverter before the automatic recognition is
performed.
●
Connect all the stations of inverters with GOT before the automatic recognition is performed. The
inverter newly added after automatic recognition is not recognized automatically. (When an
inverter is added, perform the initial setting in Pr. 999 "Automatic parameter setting" or set the
automatic recognition on the GOT side again.)
Automatic change item
Automatic change parameter
Setting value after change
PU connector connection
RS-485 terminal
connection
Communication speed Pr. 118 Pr. 332
Depending on the setting of
the connected device on the
GOT side.
Data length/stop bit Pr. 119 Pr. 333
Parity Pr. 120 Pr. 334
Waiting time setting Pr. 123 Pr. 337
CR/LF selection Pr. 124 Pr. 341
Number of communication
retries
Pr. 121 Pr. 335 9999 (fixed)
Communication check time
interval
Pr. 122 Pr. 336 9999 (fixed)
Protocol selection
— (Pr. 549 holds the value
before the automatic
recognition.)
Pr. 549
0 (fixed to Mitsubishi inverter
protocol)
Tab. 5-280: Automatic parameter change with GOT
NOTES If the automatic recognition cannot be performed, initial setting in Pr. 999 is required.
For connection to a device other than the GOT2000 series, initial setting in Pr. 999 is required.
For details, refer to the GOT2000 Series Connection Manual (Mitsubishi Product).
Parameters referred to
Pr. 999 Automatic parameter setting => page 5-80