IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 224 / 402

a. Locate the lowest-numbered, empty
memory-module connector on the processor
board.
b. Turn the memory module (DIMM)
.6/
so that the
pins align correctly with the connector
.4/
.
c. Insert the DIMM into the connector by pressing
on one edge of the DIMM and then on the other
edge of the DIMM. Be sure to press straight into
the connector.
d. Repeat the preceding step to make sure the
DIMM is seated correctly.
e. Make sure the retaining clips
.5/
are in the
closed position.
f. If a gap exists between the DIMM and the
retaining clips, the DIMM has not been properly
installed. In this case, open the retaining clips
and remove the DIMM; then, reinsert the DIMM.
g. Repeat these steps for each memory module
that you install.
5. If you have other options to install or remove, do so
now; otherwise, go to “Completing the installation” on
page 154.
216
Netfinity Server HMM