IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 242 / 402

Preparing the rack
Caution
Use safe lifting practices when lifting the machine.
In this section, you will use the following parts:
Ÿ
IBM Installation Template
Ÿ
Two slide-bracket assemblies
Ÿ
One cable-management arm
Ÿ
Two bezel brackets
Ÿ
Six screws (for attaching the bezel brackets)
Ÿ
Sixteen long screws (M6 by 16 mm)
Ÿ
Eight short screws (M4 by 8 mm)
Ÿ
Six cage nuts
Ÿ
Two hex nuts (M6)
Ÿ
Four lift handles (shipped with some servers)
Ÿ
Cable ties
Ÿ
One server bracket (for attaching the cable
management arm to the server)
Attention
To ensure rack stability, plan the installation of servers
in the rack starting from the bottom.
To attach the mounting hardware to the rack:
1. Remove the rack front door. Refer to the rack
documentation for instructions.
2. Mark the positions of the slide-bracket assemblies,
bezel brackets, and the cable-management arm on
the rack:
a. Position the installation template on the front
mounting rails on the rack, aligning the holes.
b. Mark the holes for the slide-bracket assemblies
and bezel brackets.
c. Move the template to the same U level at the
rear of the server and mark the locations for the
slide-bracket assemblies and cable-management
arm.
d. Install the six cage nuts at the locations marked
on the mounting rails.
k
32 kg (70.5 lbs)
k
55 kg (121.2 lbs)
234
Netfinity Server HMM