IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 216 / 402

hot-swap tray
.5/
; then, remove the connector
from the back of the drive.
b. Remove the four screws
.3/
(for a half-high
drive) or
.4/
(for a slim-high drive) that attach
the drive
.6/
to the hot-swap tray, and remove
the drive from the tray.
4. Place the new hard disk drive on the hot-swap tray
and attach the drive to the tray using four screws, as
follows:
a. If the drive is a half-high drive, use screws
.3/
to
attach the drive to the tray. If the drive is a
slim-high drive, use screws in holes
.4/
to attach
the drive to the tray.
b. As you tighten each screw, press on the metal
spring nearest the screw at the point indicated
by the arrow on the illustration.
c. If the drive is a half-high drive, plug the
connector
.7/
to the back of the drive and
secure the connector to the drive with screws
.8/
. (Slim-high drives do not need the
connector.)
5. Install the hard disk drive in the hot-swap bay:
a. Ensure the tray handle is open (that is,
perpendicular to the drive).
b. Align the drive/tray assembly so that it engages
the guide rails in the bay.
c. Push the drive assembly into the bay until the
drive connects to the backplane.
d. Push the tray handle to the right until it locks.
6. Check the hard disk drive status indicators to verify
that the hard disk drive is installed properly.
7. Close and lock the server door.
208
Netfinity Server HMM