IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 109 / 402

Using the ServeRAID Configuration
program
After the ServeRAID Configuration program starts, one of
the following screens will appear:
Ÿ
If you have more than one ServeRAID controller in
the system, a screen similar to the following appears.
Note
You can install multiple ServeRAID adapters in
the server, but you must configure each adapter
separately.
Multiple IBM ServeRAID Adapter found in the system. Select a choice using the Up
Arrow ( ) and Down Arrow ( ) keys and press Enter.
Select Adapter
1. Help
2. ServeRAID Adapter 1
3. ServeRAID Adapter 2
4. Exit
IBM ServeRAID Adapter Disk Array Configuration Utility Ver. X.XX
Note
In the upper-right corner of the screen, you will
see Ver. x.xx. On the screen, the x.xx is
replaced by the version number of the
configuration program.
Use the Up Arrow (
↑
) or Down Arrow (
↓
) key to
highlight your choice; then, press Enter. The Main
Menu appears.
Ÿ
If you have only one ServeRAID controller installed in
the server, the Main Menu appears.
Select a choice using the Up Arrow ( ) and Down Arrow ( ) keys and press Enter.
Press Esc to return to previous menu.
Main Menu
1. Help
2. View Configuration
3. EZ-RAID Configuration
4. Create/Delete/Copy Log Drive
5. Initialize/Synchronize Log Dr
6. Rebuild/Device Management
7. Advanced Functions
8. Exit
IBM ServeRAID Adapter Disk Array Configuration Ver. X.XX
Adapter Number: 1 Bus Number: 0 Host ID = Null Config
Netfinity 5500 - Type 8660
101