IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 191 / 402

To add a power supply:
Caution
Never remove the cover on a power supply or any
part (power backplane and ac box) that has the
following label attached.
Hazardous voltage, current, and energy levels are
present inside the power supplies, power backplane,
and ac box. There are no serviceable parts inside the
power supplies, power backplane, or ac box.
Note
It is not necessary to turn the Power switch on the
power supply off when you are installing a power
supply.
1. Remove the filler panel
.3/
:
a. Remove the four screws
.2/
from the filler panel.
b. Remove the filler panel
.3/
from the
power-supply bay and save it and the four
screws you removed for future use.
Note
During normal operation, each power-supply
bay should have either a power supply or
filler panel installed for proper cooling.
2. Place the handle
.5/
on the power supply in the open
position, and slide the power supply into the chassis.
3. Gently close the handle
.5/
on the power supply to
seat the power supply in the bay.
4. Plug the power cord for the added power supply into
power cord connector
.1/
.
Caution
When the power-cord strain-relief bracket option
is installed on the power cord, the server must be
plugged to a power source that is easily
accessible.
5. Install a power-cord strain-relief bracket
.1ð/
, if
desired.
6. Plug the power cord into a properly grounded
electrical outlet.
Netfinity 5500 - Type 8660
183