IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 26 / 402

Administration and Monitoring Utility
Program
The IBM ServeRAID Administration and Monitoring utility
program monitors the ServeRAID controller while the
network operating system is up and running.
The Administration and Monitoring utility program comes in
three versions:
Ÿ
IBM OS/2
Ÿ
Novell NetWare/IntraNetware
Ÿ
Microsoft Windows NT and Windows 95
The OS/2 and NetWare/IntraNetware utility programs run
on the server in the stand-alone mode only.
The Windows NT/Windows 95 Administration and
Monitoring utility program runs on the server in the
stand-alone mode, or in a client/server environment in the
client/server mode. You can use the stand-alone mode to
administer and configure the ServeRAID controller while at
the server. You can use the client/server mode to
administer and configure ServeRAID controllers and
adapters that are in servers anywhere on the network.
The TCP/IP networking protocol supports the client/server
mode and allows connections to IBM OS/2, Microsoft
Windows NT, Novell NetWare/IntraNetware and SCO
OpenServer operating systems.
Note
The Windows NT and Windows 95 utility programs are
required to use the logical-drive migration feature.
See “Logical drive migration administration” on
page 38.
TCP/IP
Server Client
ServeRAID
Server Utility
(OS/2, NT, NetWare, SCO)
Admin Program
(if WinNT Server)
Admin Program
(if Win95 or
WinNT Client)
This section provides installation instructions for the
following ServeRAID utility programs.
Ÿ
The Administration and Monitoring utility program runs
on a Windows-based system (Windows 95, Windows
NT Workstation, or Windows NT Server).
Ÿ
Server Utilities
– OS/2 Server Utility
18
Netfinity Server HMM